HP Surestore FC Swtich 6164 Quick Start Guide

Installing the Switch 27
c. Insert the screws you removed in Step 6a through the slotted holes in
the stationary plate and into the second set of threaded holes in the
adjustable plate from the rack-mounting flange (see Figure 14). Do
not tighten the screws at this time.
d. Repeat Steps b and c for the rack-mount bracket on the opposite side
of the switch.
e. Move the switch forward in the rack as far as it can go. The amount
of movement is limited by the rack-mount bracket adjustable plates
contacting the rack uprights.
WARNING
The FC 6164 weighs approximately 200 pounds.Two or
more people are required when positioning the switch in the rack. Move
the switch chassis slowly and carefully at all times, and continue
supporting it until it is correctly positioned on the rail tray and fastened
to the rack. Use extreme caution when handling or transporting the
switch to prevent injury to personnel, damage to the switch, and/or
damage to the rack and other equipment mounted in it.
f. Put flat washers on four 1/4-20 screws with captive lock washers, and
insert the screws through the holes in the rack uprights and into the
threaded holes in the flanges of the rack-mount bracket adjustable
plates (see Figure 14). Do not tighten the screws at this time.
Figure 14. Re-attaching the Rack-Mount Bracket Adjustable Plates