HP Surestore FC Swtich 6164 Quick Start Guide

38 Quick Start Guide
Note
If a switch boot failure occurs, the switch must be taken offline
for repair or replacement. Contact your switch supplier for assistance.
3. If the factory-set IP address is compatible with your network, connect the
Ethernet connection.
Note
The factory-set IP address is: 10.77.77.77. The Subnet Mask is:
255.255.255.0.
4. If the factory-set IP address is not compatible with your network, connect
the serial port connection, then follow the procedure to set the IP address
on page 39.
5. Monitor the status indicators for port status, see “Status Indicators” on
page 40.
If a malfunction occurs during POST, specific error messages are written to
the system error log and can be analyzed via a Telnet session when the
POST session completes. If the malfunction prohibits the switch from
completing the boot process (fatal error), the switch stops the boot process.
If the switch does not fully boot, the switch prompt will not be displayed
when the serial port is connected.
Serial Port and Ethernet Connections
The 2250 switch contains a serial port for initial configuration and an
Ethernet connection for remote monitoring and testing.
Ethernet Connection
An Ethernet connection must be established to obtain access to the internal
SNMP agent in the switch and local area network (LAN). Once the
connection is made, remote Telnet and Web access is made available. To
establish an Ethernet connection, connect to an existing Ethernet
10/100BaseT LAN via the front panel RJ45 connector.
Note
Remove shipping plug from the Ethernet port before inserting
Ethernet cable.