HP Surestore FC Swtich 6164 Quick Start Guide

40 Quick Start Guide
8. At the prompt, type the command
ipAddrSet
, then press
Enter
9. When prompted, provide the IP Address, Subnet mask, and Gateway
Address in the standard IP form of xxx.xxx.xxx.xxx.
Note
For now, only edit the Ethernet addresses, not the Fibre Channel
address.
10.When prompted type
y
and press
Enter
to apply the new values.
11.Power down the switch and disconnect the serial cable (and adapter, if
used). Connect the switch to a 10/100BaseT Ethernet connection.
12.Power up the switch. IP-based management (Telnet, SNMP, or WebTools)
can now be accessed by using the newly defined IP address.
13.Record the IP address on the label provided on the switch.
Status Indicators
Each port contains an LED that indicates the status for that port. Table 3
describes the status indicators and possible corrective actions.
Table 3. Status Indicators and Corrective Actions
LED Description Action
No light showing No light or signal carrier (no
module, no cable) for media
interface LEDs.
Check media
connection.
Steady yellow Receiving light or signal
carrier, but not yet online.
No action required.
Slow yellow Disabled (result of diagnostics
or port Disable command).
Flashes every 2 seconds.
Reset at management
station.
Fast yellow Error, fault with port. Flashes
every 1/2 second.
Reset switch.
Steady green Online (connected with device
over cable).
No action required.