Service and User Manual (Short- and Long-Wave)

82 If Firmware Upgrade Appears to Fail

3. Press <ENTER>. The screen displays status messages; for example:

FLASH programming will take about 40 seconds

FLASH pgm:[$001000:$101000)->[$800000:$900000) >

Caution Do not interrupt the display or press any keys during this process.

After about 40 seconds, the display continues.

When FLASH programming is completed, the checksum appears; for example:

FLASH programming will take about 40 seconds

FLASH pgm:[$001000:$101000)->[$800000:$900000) > complete, no errors

New FLASH checksum = 0x12FC

The value displayed can be different from the example shown here. Then the Boot

menu appears again.

Reinstalling the Hub Controller Firmware

1. From the Boot menu, enter 2 to update the hub controller firmware.

2. From the terminal emulator application, select the transfer option to send a text file.

The screen displays status messages and progress indicators; for example:

Ready to download Hub-Controller code to RAM

Start ASCII file (S-record format) transfer now

Press control-C at any time to cancel

3. Send the following file you previously downloaded from the Hewlett-Packard Software

Depot:

IFCH3718.FRM

Several rows of dots appear to indicate download progress; for example:

...................................................................

...................................