Hardware Operator's Guide

Operating in Manual Mode
3-20
Mounting a Cartridge into a 9840 Drive
To mount the cartridge in a 9840 drive:
1. Insert the cartridge into the 9840 drive using the direction shown in
Figure 3-13.
2. Wait for one of the following messages to display and take the appropriate
action, if necessary:
• The “Ready F” (File Protected) message displays when a write-protected
cartridge loads successfully.
• The “Ready U” (File Unprotected) message displays when a cartridge
that is not write-protected loads successfully.
• The “NTReady” message displays when the tape in the cartridge has lost
tension. If this occurs call your Customer Support Engineer
• The LOADxxxx” message displays when the cartridge unsuccessfully
loads, where the xxxx is a fault symptom code. If this occurs call your
Customer Support Engineer.