HP SureStore E Tape Library Model 6/140 User's Guide

Library Administration
Setting SCSI IDs
Chapter 33-20
NOTE SCSI ID 7 is not used as the default for drive position 7 because it is
typically used by the host computer (see Table 3-5 on page 3-20). Each
device on the same SCSI bus must have its own unique SCSI ID.
CAUTION Changing SCSI ID settings from factory defaults may affect the backup
software configuration. Consult your backup software manual for SCSI
ID requirements.
The SCSI ID for a drive position can be configured, even when no drive is
present. When a drive is later added, it will use the ID already assigned
to that location.
Table 3-5 Default SCSI IDs
Device SCSI ID
Library controller 0
Drives: (see page 1-12 for drive numbering scheme)
• Position 1 1
• Position 2 2
• Position 3 3
• Position 4 4
• Position 5 5
• Position 6 6
• Position 7 8
• Position 8 9
• Position 9 10
• Position 10 11
• Position 11 12
• Position 12 13