SAN Solution Installation Guide

Installation
Tape Libraries
Chapter 22-24
Setting the Date
The library saves the current data and time in non-volatile memory.
You can set the date from the library configuration screen. To set this
value:
1. At the
Library Configuration menu, press an arrow button until the
cursor underscores
DATE.
2. Press the
[SELECT] button. An editing screen appears.
3. On the editing screen:
— Use the arrow keys to select a value for each portion (field) of
the date.
— Use the
[SELECT] button to move right to the next field.
— Use the
[MENU] button to move left to the previous field.
4. When the screen displays your desired setting, press the
[SELECT]
button from the right-most field to save the changes. To abort, press
the
[MENU] button from the left-most field.
5. If you have already changed the library’s SCSI ID and are planning to
exit the
Main Configuration menu at this time, you must press the
[RESET] button. If you wish to set other configuration values, continue
with the next section, “Setting the Time.”
Setting the Time
You can set the time from the library configuration screen. To set this
value:
1. At the
Library Configuration menu, press the arrow button until the
cursor underscores
TIME.
2. Press the
[SELECT] button. An editing screen appears.
3. On the editing screen:
— Use the arrow keys to select a value for each portion (field) of
the time.
— Use the
[SELECT] button to move right to the next field.
— Use the
[MENU] button to move left to the previous field.