HP StorageWorks 200 Storage Virtualization System site preparation guide (AE071-96003, October 2006)

Checking for shipping shortage and damage

Upon delivery of each equipment shipment:

1. Check the carrier’s bill of lading to ensure that the items listed match the items delivere d. Notify the

carrier immediately if there are any discrepancies or missing items.

2. Inspect all shipping c ontainers for signs of damage, such as dents, scratches, cuts, or water marks.

3. If you see any damage to the containers:

a. N ote on the

bill of lading that there is apparent damage, subject to inspection.

b. Arrange f

or the carrier’s representative and an HP representative to be present when the item in

question is unpacked.

c. Contact your HP representative, who will make sure any damaged components are replaced,

regardless of the circumstances and without waiting for any claim settlements.

Unpacking the equipment

HP representatives will supervise the unpacking and moving of the system equipment. It is your

responsibility to receive, unpack, and move the equipment to the installation locations. If necessary, an

HP representative can oversee these tasks as part of installation.

Required personnel

HP reco

mmends that two or three physically able personnel be available to assist with ofﬂoading the

syste

m equipment from the pallet. Personnel must be knowledgeable and experienced with the safe

handl

ing of large, heavy, and sensitive com puter equipment.

Required tools

• Claw hamm er (if full packaging with wooden cra te)

• Ratchet wrench or box-open end wrench sizes 11mm (7/16") and 19mm (3/4"), or adjustable

end wrench

• 6mm hex wrench

• Scissors or box knife to cut polyester banding

• Safety glasses

• Short stepladder (helpful, but not required)

Delivery and unpacking