PCoIP Management Console User Manual (Issue 12)

PCoIP Management Console User Manual
TER0812002 Issue 12 40
3.6 Change Time Zone
The MC retrieves the current time from the host machine. The host machine provides this
time in Coordinated Universal Time (UTC) form. Because the host does not provide time
zone information, you must configure the time zone.
To configure the time zone:
1. Select the Change timezone option on the MC VM console.
2. Select a geographic area that determines the time zone. For example, select America/New
York if located in the same time zone as New York City.
Note: You can use the MC without configuring the time zone. If you do not configure the
timezone, the time that appears at the top of the MC VM console is incorrect and the
timestamps that appear on various screens in the MC web interface is incorrect.
3.7 Restart Management Console Daemon
To restart the MC daemon, select the Restart MC daemon option on the MC VM console. A
message indicating the daemon is restarting appears on the MC VM console. This lets you
know when the restart is complete.
You should execute this command:
 If the MC daemon status reported on the console interface shown in Figure 3-1 is
stopped.
 If the Management Console Health shown in the Site Status section of the Home
page is not “Good”.
3.8 Halt Virtual Machine
To perform a clean shutdown of the MC VM, select the Halt virtual machine option on the
MC VM console. You can restart the MC VM at a later time. When the MC VM is restarted,
the MC database is restored to the state it was in when the MC VM was last stopped.