PCoIP Management Console User Manual (Issue 12)

PCoIP Management Console User Manual
TER0812002 Issue 12 60
 OSD logo done: The MC completed writing the OSD logo to the device.
 firmware pending reboot: The MC completed writing the profile’s selected
firmware to the device and requires a reboot before the profile properties are written.
 firmware done: The MC has completed writing the profile’s selected firmware to
the device which was also rebooted.
 SCEP pending: The MC has completed writing the profile to the device and requires
the SCEP certificate installation to finish before completing the profile application.
 unapplied: The profile was modified since it was last written to the device. This lets
you know when you must reapply a profile to one or more devices in a group.
Figure 4-17: View Profile Application Status Webpage
4.3.3 Manage AutoConfig
The Manage AutoConfig subcategory, shown in Figure 4-18, lets you enable or disable the
AutoConfig feature and configure the AutoConfig rules. By default, AutoConfig is disabled
and no AutoConfig rules are defined.
You can optionally create an AutoConfig rule for each group. Newly discovered zero client
devices are automatically added to a group and have that group's profile applied when
conditions 1, 2 and 3 are true.
 Condition 1
The AutoConfig feature is enabled.
 Condition 2
The group's AutoConfig rule has no IP address ranges.
OR
The zero client's IP address is within one of the rule's IP ranges.
OR
The DHCP Option Matching is on. The MC AutoConfig Group
option is set to the identical group name, and the MC AutoConfig
Behavior option is not set to 2.
See section 1.3.3.1 for details on configuring DHCP Vendor Class Options.