PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameters Description
You can choose to display:
1. Show All messages – This option shows all disconnect
messages including Info, Warning, and Error messages.
2. Show Error and Warnings Only – This option hides info
messages and displays only error and warning messages.
3. Show Error Only – This option hides Info and Warning messages
and displays only Error messages.
4. Show None – Don’t show any disconnect messages.
Enable DSCP When enabled, the device populates the Differentiated Services
Code Point (DSCP) field in the IP header, allowing intermediate
network nodes to prioritize PCoIP traffic accordingly.
Enable Transport
Congestion Notification
When enabled, transport congestion notification is enabled to allow
PCoIP endpoints to react accordingly if an intermediate network
node sets the congestion notification bit in either the IP header or
PCoIP transport header.
Note: For more information about the PCoIP transport header, see
PCoIP Packet Format.
7.7.13 AWI Client: Direct to Host + SLP Host Discovery Session
Settings
Select the Direct to Host + SLP Host Discovery session connection type from the
Configuration > Session page to configure the client to connect directly to a host and to use
Service Location Protocol (SLP) to discover the host automatically.
TER1206003 Issue 5 155
PCoIP® Zero Client and Host Administrator Guide