PCoIP Zero Client and Host Administrator Guide (Issue 5)

Table 4-52: MC Bandwidth Configuration Parameters
Parameter Description
Device Bandwidth Limit Enter the maximum bandwidth peak for hosts or clients. When
configuring hosts, this setting defines the bandwidth from the host to
the client (e.g., graphics data). When configuring clients, it defines
the bandwidth from the client to the host (e.g., USB data).
The usable range of the device bandwidth is 1000 to 220000 Kbps.
The PCoIP processor only uses the required bandwidth up to the
Device Bandwidth Limit maximum, and dynamically adjusts the
bandwidth in response to network congestion. Setting this field to 0
configures the PCoIP processor to use the maximum rate available in
the network at any time.
We recommend setting this field to the limit of the network connected
to the client and host.
Note: When applied to devices running firmware older than 3.0, a
value other than 0 is rounded to the nearest Megabit per second,
with a minimum value of 1 Mbps.
Device Bandwidth
Target
Enter the temporary limit on the network bandwidth during periods of
congestion. When the host or client detects packet loss, the device
bandwidth is rapidly reduced to this value, and then more slowly
reduced below it.This allows for a more even distribution of
bandwidth between users sharing a congested network link.
Note: When applied to devices running firmware older than 3.0, a
value other than 0 is rounded to the nearest Megabit per second,
with a minimum value of 1 Mbps.
TER1206003 Issue 5 240
PCoIP® Zero Client and Host Administrator Guide