PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameter Description
Disable Build to
Lossless
Leave this field unchecked to retain the PCoIP protocol's build-to-
lossless feature, where images continue to be refined in the
background until they reach a fully lossless state (i.e., identical pixel-
for-pixel rendering when compared to the host image source). This is
the default (recommended) setting.
Warning: Turning on the Disable Build to Lossless field will
degrade the image presented to the user by the zero client. Do not
turn on this field unless it has been determined by the administrator
of the zero client that users do not require optimal image quality to
perform critical functions. It is the sole responsibility of the zero client
administrator to make this determination.
If you do choose to turn on this field, the PCoIP protocol rapidly
builds the client image to a high quality image that may be
perceptually lossless, but is not a fully lossless state. This may
provide some bandwidth savings, but is not recommended for use
cases that require images and desktop content to be truly lossless.
If you have any questions about this field setting, contact Teradici
support.
Note: This setting does not work in PCoIP sessions with VMware
View virtual desktops running release 5.0 or earlier.
Enable Client Image
Settings
When enabled, allows the host the option of using the client's image
settings for the session. When disabled, the host's image settings
take effect.
Note: The Image Quality Preference setting is exempt from this rule.
Maximum Frame Rate The maximum frame rate helps you manage multiple PCoIPsessions
over a single network link. This setting determines the limit that your
users can reach. Set this field to 0 to set no frame limit. If you set a
value, a single user is limited to that value. This helps to control the
user experience for all your users.
Note: This setting does not work in PCoIP sessions with VMware
View virtual desktops running release 5.0 or earlier.
7.12.2 AWI Host: Image Settings
The Image page lets you make changes to the image quality of the PCoIP session. You can
display this page from the Configuration > Image menu.
Note: This setting applies only to sessions between zero clients and hosts.
TER1206003 Issue 5 250
PCoIP® Zero Client and Host Administrator Guide