PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameter Description
Preferred Override
Resolution on Port 3
When enabled, this property allows you to select a preferred override
resolution for the display attached to the specified port. If the display
does not support the resolution you select from the drop-down list,
the display's native resolution will be used.
Note: The Enable Preferred Resolution Override property must be
enabled and set to True when this feature is configured.
Note: Setting a dual-link only resolution on a device with a single-link
display attached to this port will cause the profile application to fail.
Preferred Override
Resolution on Port 4
When enabled, this property allows you to select a preferred override
resolution for the display attached to the specified port. If the display
does not support the resolution you select from the drop-down list,
the display's native resolution will be used.
Note: The Enable Preferred Resolution Override property must be
enabled and set to True when this feature is configured.
Note: Setting a dual-link only resolution on a device with a single-link
display attached to this port will cause the profile application to fail.
7.13.2 AWI Tera1 Host: Monitor Emulation
The Monitor Emulation page lets you enable or disable the monitor emulation feature. This
page is only available on host cards still using monitor emulation. It is disabled and non-
editable on the client.
Some PCs and workstations do not boot if a display is not attached. Monitor emulation
presents a generic display to ensure the boot process completes. When a session is
connected, the client display information is sent to the host.
You can display this page from the Configuration > Monitor Emulation menu.
Figure 4-67: AWI Tera1 Host Monitor Emulation Page
TER1206003 Issue 5 258
PCoIP® Zero Client and Host Administrator Guide