PCoIP Zero Client and Host Administrator Guide (Issue 5)

Table 4-63: AWI Tera1 Host Monitor Parameters
Parameter Description
Enable Monitor
Emulation on DVI-1
When enabled, the host responds to all Display Data Channel (DDC)
queries, regardless of whether a PCoIP session is active. If a session
is not active, the host provides emulated DDC data. If a session is
active, the host provides actual DDC data gathered from the monitor
connected to the client's port 1 connector.
When disabled, the host only responds to Display Data Channel
(DDC) queries when a PCoIP session is active.
Note: Enabling this field can help resolve problems where video is
not present at the client.
Enable Monitor
Emulation on DVI-2
This field affects DDC queries for the port 2 connector, and provides
functionality similar to that for the port 1 connector.
7.13.3 AWI Tera2 Host: Monitor Emulation
The Monitor Emulation page lets you enable or disable the monitor emulation feature. This
page is only available on host cards still using monitor emulation. It is disabled and non-
editable on the client.
Some PCs and workstations do not boot if a display is not attached. Monitor emulation
presents a generic display to ensure the boot process completes. When a session is
connected, the client display information is sent to the host.
You can display this page from the Configuration > Monitor Emulation menu.
Figure 4-68: AWI Tera2 Host Monitor Emulation Page
TER1206003 Issue 5 259
PCoIP® Zero Client and Host Administrator Guide