PCoIP Zero Client and Host Administrator Guide (Issue 5)

Table 4-64: AWI Tera2 Host Monitor Parameters
Parameter Description
Enable Monitor
Emulation on Video Port
1
When enabled, the host responds to all Display Data Channel (DDC)
queries, regardless of whether a PCoIP session is active. If a session
is not active, the host provides emulated DDC data. If a session is
active, the host provides actual DDC data gathered from the monitor
connected to the client's port 1 connector.
When disabled, the host only responds to Display Data Channel
(DDC) queries when a PCoIP session is active.
Note: Enabling this field can help resolve problems where video is
not present at the client.
Enable Monitor
Emulation on Video Port
2
This field affects DDC queries for the port 2 connector, and provides
functionality similar to that for the port 1 connector.
Enable Monitor
Emulation on Video Port
3
This field affects DDC queries for the port 3 connector, and provides
functionality similar to that for the port 1 connector.
Enable Monitor
Emulation on Video Port
4
This field affects DDC queries for the port 4 connector, and provides
functionality similar to that for the port 1 connector.
Enable Host Hot-Plug
Delay
When enabled, allows lengthier hot plug de-assert/assert profiles on
the host. Enabling this feature allows the host to resolve black screen
issues with certain Linux GPU driver timing expectations.
7.14 Configuring Time
7.14.1 MC: Time Settings
The Time page lets you configure a profile with the Network Time Protocol (NTP)
parameters to use to allow the host and client event logs to be time-stamped based on NTP
time.
Note: If the client is configured for DHCP and the DHCP server provides an NTP server
address, this address will override any manually configured NTP server. It will also enable
NTP if it is disabled.
Note: The client does not get time zone or Daylight Saving Time (DST) information from
the NTP server.
Note: To simplify system troubleshooting, set the NTP parameters to allow user events to
correlate with the relevant diagnostic event log entries.
Note: To enable a property in the MC, click the Set in Profile checkbox and configure the
fields as indicated. After you update the properties on this page, click Save to save your
changes.
TER1206003 Issue 5 260
PCoIP® Zero Client and Host Administrator Guide