PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 4-69: MC Time Configuration
Table 4-65: MC Time Configuration Parameters
Parameter Description
NTP Server Hostname Configure the IP address or fully qualified domain name (FQDN) of
the NTP server that the host or client will contact to determine the
current time.
NTP Server Port Configure the port number of the NTP server. The default NTP server
port value is 123.
NTP Query Interval Configure how often (in seconds) the host or client will contact the
NTP server to update the current time. The default query interval is
86400 seconds, which is equivalent to 24 hours.
Enable DST Enable or disable the automatic adjustment for Daylight Saving Time
(DST).
Time Zone Offset Select the desired time zone.
7.14.2 AWI: Time Settings
The Time page lets you configure Network Time Protocol (NTP) parameters to allow the
host and client event logs to be time-stamped based on NTP time.
Note: If the client is configured for DHCP and the DHCP server provides an NTP server
address, this address will override any manually configured NTP server. It will also enable
NTP if it is disabled.
Note: The client does not get time zone or Daylight Saving Time (DST) information from
the NTP server.
TER1206003 Issue 5 261
PCoIP® Zero Client and Host Administrator Guide