PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 4-77: AWI Tera2 Host Power Page
Table 4-73: AWI Tera2 Host Power Page Parameters
Parameter Description
Host Wake
Options
Configure the wake method used on the host when it is in sleep mode and a
Wake-on-LAN magic packet is detected:
l Remote Power Button: If the host has the host card power button cable
installed, select this option to route Wake-on-LAN packets to the host
card via the host PC's front panel power button.
l PCIe Wake Input: If the host PC cannot provide sufficient standby power
to the host card, select this option to route Wake-on-LAN packets first to
the host PC, and then to the host card via the PCIe bus.
Note: For more information, see Knowledge Base support topic 15134-201
on the Teradici support site.
Enable Wake-on-
LAN
When enabled, configures the host to wake up from sleep mode when the
user sends Wake-on-LAN magic packets to the host by pressing the client's
remote PC button or clicking the OSD Connect button on the OSD Connect
window.
7.17.3 AWI Tera2 Client: Power Permissions
The Power page lets you configure timeout and power settings for the client. You can
access this page from the Configuration > Power menu.
TER1206003 Issue 5 271
PCoIP® Zero Client and Host Administrator Guide