PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 4-78: AWI Tera2 Client Power Page
Table 4-74: AWI Tera2 Client Power Page Parameters
Parameter Description
OSD Screen-
Saver Timeout
Configure the number of seconds to wait after a period of inactivity (i.e., no
keyboard or mouse action) before the client puts its attached displays into
low power mode. Valid values are 10 to 9999, or use 0 to disable the
feature.
Note: This timeout only applies when the device is not in session.
Display Suspend
Timeout
Configure the number of seconds to wait after a period of inactivity (i.e., no
keyboard or mouse action) before the client puts its attached displays into
low power mode. Valid values are 10 to 14400 seconds, or use 0 to disable
the feature.
Note: This timeout only applies when the device is in session.
Auto Power-Off
Timeout
Configure the number of seconds to wait after a period of inactivity (i.e., no
keyboard or mouse action) before the client powers down. Valid values are
60 to 28800 seconds, or use 0 to disable the power down.
Note: Non-zero values are only allowed when the PCoIP client supports
powering off.
Note: This timeout only applies when the device is not in session.
Remote Host
Power Control
Configure the functionality of the client's remote PC button.
Select from the following options:
l Power-off not permitted: Users cannot shut down the host or put it in
sleep mode.
l Hard Power-off only: Users can shut down the host but not put it in
sleep mode.
Power On After
Power Loss
When enabled, the client automatically powers back on when power is
supplied.
TER1206003 Issue 5 272
PCoIP® Zero Client and Host Administrator Guide