PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameter Description
Enable Wake-on-
USB
When enabled, configures the host to wake up from sleep mode when the
user moves the mouse or presses a key on the keyboard.
Enable Wake-on-
LAN
When enabled, configures the host to wake up from sleep mode when the
user sends Wake-on-LAN magic packets to the host by pressing the client's
remote PC button or clicking the OSD Connect button on the OSD Connect
window.
7.17.4 AWI Tera1 Client: Power Settings
The Power page lets you configure timeout and power settings for the client. You can
access this page from the Configuration > Power menu.
Figure 4-79: AWI Tera1 Client Power Page
Table 4-75: AWI Tera1 Client Power Page Parameters
Parameter Description
OSD Screen-Saver
Timeout
Configure the number of seconds to wait after a period of inactivity
(i.e., no keyboard or mouse action) before the client puts its attached
displays into low power mode. Valid values are 10 to 9999, or use 0
to disable the feature.
Note: This timeout only applies when the device is not in session.
Auto Power-Off Timeout Configure the number of seconds to wait after a period of inactivity
(i.e., no keyboard or mouse action) before the client powers down.
Valid values are 60 to 28800 seconds, or use 0 to disable the power
down.
Note: Non-zero values are only allowed when the PCoIP client
supports powering off.
Note: This timeout only applies when the device is not in session.
TER1206003 Issue 5 273
PCoIP® Zero Client and Host Administrator Guide