PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 4-87: MC Peripheral Configuration
Table 4-83: MC Peripheral Configuration Parameters
Parameter Description
Enable USB EHCI When enabled, configures EHCI (USB 2.0) for devices connected directly to
zero client USB ports for sessions with a host running VMware View 4.6 or
later.
Note: This feature cannot be enabled on clients with less than 128 MB of
RAM. Devices with isochronous endpoints will not operate at USB 2.0
speeds.
7.20.2 AWI Client: Help for Peripheral Settings
Peripheral USB EHCI settings for the AWI are located on the AWI Client: USB
Permissions page (accessed from the Permissions > USB menu).
7.21 Configuring IPv6
7.21.1 MC: IPv6 Settings
The settings on this page let you configure a profile to enable IPv6 for PCoIP devices
connected to an IPv6 network.
Note: IPv6 is not currently supported by VMware View.
Note: To enable a property in the MC, click the Set in Profile checkbox and configure the
fields as indicated. After you update the properties on this page, click Save to save your
changes.
TER1206003 Issue 5 285
PCoIP® Zero Client and Host Administrator Guide