PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 4-90: OSD IPv6 Page
Note: When you make a change to one of the settings on this page, you must reboot your
device for the change to take effect.
Table 4-86: OSD IPv6 Page Parameters
Parameter Description
Enable IPv6 Enable this field to enable IPv6 for your PCoIP devices.
Link Local Address This field is automatically populated.
Gateway Enter the IPv6 gatewayaddress.
Enable DHCPv6 Enable this field to set up Dynamic Host Configuration Protocol
version 6 (DHCPv6) for your device.
DHCPv6 Addresses When DHCPv6 is enabled and the device is rebooted, the server
automatically populates these fields with addresses for the device.
Primary DNS The device's primary DNS IP address. If DHCPv6 is enabled, this
field is automatically populated by the DHCPv6 server.
Secondary DNS The device's secondary DNS IP address. If DHCPv6 is enabled, this
field is automatically populated by the DHCPv6 server.
TER1206003 Issue 5 290
PCoIP® Zero Client and Host Administrator Guide