PCoIP Zero Client and Host Administrator Guide (Issue 5)

Table 4-96: AWI Firmware Upload Page Parameters
Parameter Description
Firmware build filename The filename of the firmware image to be uploaded. You can browse
to the file using the Browse button. The file must be accessible to the
web browser (i.e., it must be on a local or accessible network drive).
The firmware image must be an ".all" file.
Upload Click the Upload button to transfer the specified file to the device. The
AWI prompts you to confirm this action to avoid accidental uploads.
Note: It's important to ensure that both the host and client have the
same firmware release.
See Uploading Firmware in the "How To" section for information on how to use the AWI to
upload a firmware release to a zero client or host.
7.26 Configuring USB Permissions
7.26.1 MC: USB Permissions
The Profile Zero Client USB sections are located towards the bottom of the Manage
Profiles page on the Management Console. These sections let you configure a profile to
retain the USB settings that are configured on clients, to disable the settings, or to add to
them.
Note: USB Enhanced Host Controller Interface (EHCI) mode is configured in the
Management Console on the MC Peripheral Configuration page.
Figure 4-104: MC Profile Zero Client USB Configuration
TER1206003 Issue 5 307
PCoIP® Zero Client and Host Administrator Guide