PCoIP Zero Client and Host Administrator Guide (Issue 5)
Statistics Description
Endpoint Image Settings
In Use
Displays if the image settings being used are configured within the
client or within the host. This is based on how the Use Client Image
Settings field is configured on the Image page for the host device.
Image Quality The minimum and maximum quality setting is taken from the Image
page for the device.
The active setting is what’s currently being used in the session and
only appears on the host.
Image Quality
Preference
This setting is taken from the Image Quality Preference field on the
Image page. The value determines if the image is set to a smoother
versus a sharper image.
Build to Lossless Options that may appear in this field include the following:
Enabled: The Disable Build to Lossless field on the Image page is
unchecked.
Disabled: The Disable Build to Lossless field is checked.
Display The port number for the display.
Maximum Rate This column shows the refresh rate of the attached display.
If the Maximum Rate field on the Image page is set to 0 (i.e., there is
no limit), the maximum rate is taken from the monitor's refresh rate.
If the Maximum Rate field on the Image page is set to a value
greater than 0, the refresh rate shows as "User Defined."
Input Change Rate The rate of content change from the GPU. This includes everything
the user is doing (such as cursor movement, email editing, or
streaming video).
Note: This option is only available on the host. It does not appear on
the client.
Output Process Rate The frame rate currently being sent from the image engine on the
host to the client.
Image Quality Shows the current lossless state of the attached display:
l Lossy
l Perceptually lossless
l Lossless
Note: When you click the Reset Statistics button on a host Session Statistics or client
Session Statistics page, the statistics reported in the Home page are also reset.
5.2.5 Failed Login Attempt Message
As of firmware release 4.1.0, a warning message alerts you if any failed access attempts to
the AWI, OSD, or MC were detected since the last successful login. The message provides
the date and time of the failed attempt, as shown below in the example warning message on
the AWI.
TER1206003 Issue 5 45
PCoIP® Zero Client and Host Administrator Guide