PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 2-30: USB Device Not Authorized Overlay
USB Over Current Notice Overlay
If the USB devices connected to the client cannot be handled by the USB ports, the
following overlay appears with the message "USB over current notice." This overlay
remains until USB devices are removed to meet the current handling of the USB ports.
Figure 2-31: USB Over Current Notice Overlay
USB Device Not Supported Behind a High-speed Hub Overlay
Some USB devices cannot be connected through a high speed (USB 2.0) hub, and should
instead be connected directly to the zero client or through a full speed (USB 1.1) hub. If
such a device is connected to the zero client through a high speed hub, the following overlay
appears with the message "USB device not supported behind high speed hub." This overlay
lasts for approximately five seconds.
Figure 2-32: USB Device Not Supported Behind a High-speed Hub Overlay
Resolution Not Supported Overlay
If the resolution of a monitor connected to the client cannot be supported by the host, the
monitor is set to its default resolution and the following overlay appears with the message
"Resolution not supported."
Figure 2-33: Resolution Not Supported Overlay
Video Source Overlays
Improper connection of the host video source is denoted by two possible overlays. These
overlays appear for approximately five minutes. The monitor is put into sleep mode
approximately 15 seconds after they appear.
TER1206003 Issue 5 57
PCoIP® Zero Client and Host Administrator Guide