PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 3-3: Zero Client to Host Card (LAN)
To establish the connection:
1. From the zero client's AWI:
l Configure the Direct to Host session connection type, and enter the DNS name or
IP address of the host card.
2. From the host card's AWI:
l Configure the Direct from Client session connection type, and whether to accept
any peer (i.e., zero client) or a specific one.
3. Start a PCoIP session.
4. If necessary, adjust bandwidth and image parameters on both the host and client to
optimize performance.
6.4.3 Zero Client to Host Card via View Connection Server
The figure below shows a PCoIP session between a zero client and host card from within a
LAN using a View Connection Server to connect the endpoints.
Note: All host card scenarios assume you have the PCoIP host software installed on the host
PC or workstation. For details, please see "PCoIP® Host Software for Windows User
Guide" (TER1008001). This scenario also assumes you have the VMware View Agent
software installed on the host PC or workstation. For more information, see "Using PCoIP®
Host Cards with VMware View" (TER0911004). Please refer to Connection Prerequisites
for other conditions that may apply.
Figure 3-4: View – Zero Client to Host Card via View Connection Server
TER1206003 Issue 5 68
PCoIP® Zero Client and Host Administrator Guide