PCoIP Zero Client and Host Administrator Guide (Issue 5)

Figure 3-7: Remote PCoIP Sessions with Multiple Tera2 Devices
To establish the connection:
1. For the first scenario: Configure the enterprise NAT device to redirect TCP/UDP port
4172 to the host card.
For the second scenario:
l Configure the source enterprise NAT device (203.0.0.1) to translate IP address and
ports as follows:
192.168.0.1:4172 to 203.0.0.1:4172
192.168.0.2:4172 to 203.0.0.1:4173
192.168.0.3:4172 to 203.0.0.1:4174
l Configure the destination enterprise NAT device (144.0.0.1) to translate IP
addresses and ports as follows:
144.0.0.1:4172 to 10.0.10.1:4172
144.0.0.1:4173 to 10.0.10.2:4172
144.0.0.1:4174 to 10.0.10.3:4172
2. From the zero client's AWI:
l Configure the Direct to Host session connection type, and enter the IP address of
the destination enterprise NAT device.
3. From the host card's AWI:
l Configure the Direct from Client session connection type.
4. On your firewall or router, allow both TCP and UDP traffic on the ports you have
configured in your NAT devices (4172+).
TER1206003 Issue 5 72
PCoIP® Zero Client and Host Administrator Guide