PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameter Description
Enable Microsoft
®
Windows
Vista
®
64-bit Mode
Enables 64-bit mode on the host. This mode should only be used
for Windows Vista 64-bit and Windows 7
®
64-bit versions to
ensure audio works correctly.
Note: Enabling 64-bit mode is not required for Linux, Windows 7
®
32-bit, Windows Vista 32-bit, or Windows XP (32-bit or 64-bit).
Enable Audio Line In Enable: Use the line-in connector found on the client.
Disable: Use the line-in connector as a microphone input.
Follow the onscreen instructions if you have Windows Vista or
Windows 7 installed on the device.
Table 4-2: Network Parameters
Parameter Description
Enable DHCP Enables DHCP (as opposed to using manual IP address
configuration)
IP Address Device’s IP address
Subnet Mask Device’s subnet mask
Gateway Device’s gateway IP address
Primary DNS Server Device’s primary DNS IP address
Secondary DNS Server Device’s secondary DNS IP address
Table 4-3: Session Parameters
Parameter Description
Accept Any Client Lets the host accept any client for a PCoIP session.
Client MAC Address Lets you specify the client MAC address for a PCoIP session.
Note: You cannot set the client MAC address to 00-00-00-00-00-
00.
7.1.2 AWI Client: Initial Setup Page
You can display this page from the Configuration > Initial Setup menu.
TER1206003 Issue 5 86
PCoIP® Zero Client and Host Administrator Guide