PCoIP Zero Client and Host Administrator Guide (Issue 5)

Parameter Description
SNMP NMS Address If you want the device to send SNMP traps to an SNMP Network
Management System (NMS), enter the IP address or fully qualified
domain name (FQDN) of the SNMP NMS.
Enable SNMP Cold
Start Trap
When enabled, the device sends SNMP cold start traps to the SNMP
NMS after the device is powered on or reset.
Enable SNMP V1 Traps When enabled, allows generation of SNMPv1 traps.
Enable SNMP V2c
Traps
When enabled, allows generation of SNMPv2c traps.
Enable Static IP
Fallback
When enabled, the device will use the fallback IP address, netmask
and gateway when DHCP lease acquisition fails after timeout
seconds of trying.
Note: This property requires a device restart after being changed.
Static Fallback IP
Address
Configures the IP address to use when Static IP Fallback is enabled
and DHCP lease acquisition fails.
Note: This property requires a device restart after being changed.
Static Fallback Subnet
Mask
Configures the subnet mask to use when Static IP Fallback is
enabled and DHCP lease acquisition fails.
Note: This property requires a device restart after being changed.
Static Fallback Gateway
Address
Configures the gateway address to use when Static IP Fallback is
enabled and DHCP lease acquisition fails.
Note: This property requires a device restart after being changed.
Static Fallback Timeout Configures the amount of time in seconds the device will attempt to
acquire a DHCP lease before using the fallback address
configuration. You must enter a value greater than or equal to 60.
Note: It may take up to 30 seconds longer than this value for the
fallback configuration to become active.
Note: This property requires a device restart after being changed.
SNMP Community
Name
Configures the SNMP community name used by the device.
7.2.2 AWI: Network Settings
This page lets you configure network settings for the host or client. You can display this
page from the Configuration > Network menu. After you update the parameters on this
page, click Apply to save your changes.
Note: You can also configure network information from the host's Initial Setup page and
the client's Initial Setup page.
TER1206003 Issue 5 90
PCoIP® Zero Client and Host Administrator Guide