HP ThinPro, version 4.1 Administrator's Guide
Setup
These utilities enable you to set up the thin client to your requirements. The following utilities are
available on the Setup tab:
●
Date and time on page 35
●
Network on page 35
●
Language on page 39
●
Security on page 39
●
HP ThinPro configuration on page 39
Date and time
To set date, time, and time zone information:
1. Double-click Date and Time.
2. On the Timezone and Date and Time tabs, select the time zone, date, and time.
3. If you would like to use the network time server instead, select Use Network Time Server and
type the server address in the field.
4. If you would like to display the week number in the calendar, click Show Week Numbers.
5. Click Apply, and then click OK to save your changes and close the dialog box.
Network
To configure network settings:
1. Double-click Network.
2. Configure the Wired tab:
a. Enable IPv6—Check to use IPv6 connection. Default is IPv4.
b. Ethernet Speed—List of Link speed/Duplex mode pairings available.
c. Connection Method—Option to use Auto or Static connection
d. Static Address Configuration—Enable IPv6 NOT enabled
●
IP Address
●
Subnet Mask
●
Default Gateway
Control Panel
35