HP Server Ultra 3 SCSI Host Bus Adapter Installation and Configuration Guide

11
SCSISelect, included with the HP Ultra3 SCSI Host Bus Adapter, enables you to
change SCSI settings without opening the computer or handling the host bus adapter.
SCSISelect also enables you to low-level format or verify the disk media of your
SCSI hard disk drives. The following table lists the available and default settings for
each SCSISelect option.
2 Configuration with SCSISelect
NOTE The default settings are appropriate for most systems. Run
SCSISelect if you need to change or view current settings, or
if you would like to run the SCSI disk utilities.
Table 2-1. SCSI Select Options
SCSISelect Options Available Settings
Default
Setting
SCSI Bus Interface Definitions:
Host Adapter SCSI ID 0-15 7
SCSI Parity Checking Enabled, Disabled Enabled
Host Adapter SCSI Termination
LVD/SE Connectors Automatic, Enabled,
Disabled
Automatic
SE Connectors Automatic
Low ON/High ON
Low OFF/High OFF
Low OFF/High ON
Automatic
Boot Device Options:
Boot SCSI ID 0-15 0
Boot LUN Number
1
0-7 0
SCSI Device Configuration:
Sync Transfer Rate (MBytes/sec) 160, 80.0, 53.4, 40.0,
32.0, 26.8, 20.0,
16.0, 13.4, 10.0,
ASYN
160