HP Server Ultra 3 SCSI Host Bus Adapter Installation and Configuration Guide

This chapter explains how to install the HP Ultra3 Family Manager Set driver for

Windows 2000.

If you are performing a first-time Windows 2000 installation, see “Installing the

Driver When Installing Windows 2000” . If Windows 2000 is already installed in

your system, see “Installing the Driver When Windows 2000 is Already Installed”

on page 32.)

Installing the Driver When Installing

Windows 2000

1. Start your system with the Windows 2000 Operating System CD-ROM disk in

your CD-ROM drive.

2. You may see a message:

Press any key to boot from CD.

3. After Windows 2000 has completed installation, please reinstall your SCSI

driver from the Device Manager. Follow the steps in “Installing the Driver

When Windows 2000 is Already Installed” on page 32 to ensure the desired

driver is installed.

4 Microsoft Windows 2000

Installation

NOTE When using a CD-ROM drive to install Windows 2000 from

the bootable CD-ROM, make sure Bootable CD-ROM

support is enabled in either the system or SCSI BIOS setup

utility. If these options are not available, boot from the

Windows 2000 floppy disks.