HP Server Ultra 3 SCSI Host Bus Adapter Installation and Configuration Guide

41
This chapter explains how to install the HP Ultra3 Family Manager Set driver <File
Name>adpt160m.ham for Novell NetWare— NetWare 5.0, 5.1, and 6
.0.
If you are performing a first time NetWare installation, see “Installing the Driver
When Installing NetWare” in the next section. If NetWare is already installed in
your system, see “Installing the Driver When NetWare is Already Installed” on
page 44.
Installing the Driver When Installing NetWare
To install the <File Name>adpt160m.ham driver when you install NetWare, follow
the instructions below for the version of NetWare you are installing.
NetWare 5.0/5.1/6.0
Follow these instructions only if you are installing NetWare 5.0, 5.1 or 6.0 for the
first time:
1. Begin installation of NetWare 5.0 on your server as instructed in your NetWare
documentation.
2. When a screen appears that asks you to add device drivers, select Modify and
press Enter.
3. Select “Storage adapters,” and press Enter.
4. Press Insert to add storage drivers.
5. Press Insert to add an unlisted driver.
6. Insert the HP Ultra3 Family Manager Set disk for NetWare into your floppy disk
drive.
7. Press F3 and enter path to the HP Ultra 3 SCSI Host Bus Adapter driver for the
version of NetWare being installed.
8. Select adpt160m.ham and press Enter.
9. Select “Return to driver” list, and press Enter.
10. To install additional adapters, follow the procedures from Step 4.
11. When complete, select Continue to complete the installation.
5 Novell NetWare Installation