Upgrading and Servicing Guide

12 647642-001 — Removing and Replacing a Hard Disk Drive
3 Set the hard drive cage down into the bay, aligning
the tabs on the bottom of the cage with the tabs on the
chassis. Slide the drive back toward the center of the
computer until it stops, ensuring that the connector on
the end of the drive is properly seated.
4 Tighten the captive screw with a flathead or Torx
screwdriver, to secure the hard drive cage in place.
5 Reinstall the drive door by sliding it toward the center
of the computer.
6 Slide the drive door to the edge of the computer
making sure to align the screw hole in the drive door
to the screw hole on the computer.
7 Install the screw securing the door to the back of the
computer.