Upgrading and Servicing Guide

647642-001 — Upgrading or Replacing Memory 17
7 Lay the computer down on a flat surface, covered with
a soft cloth to protect the screen from scratches or
other damage. Make sure the stand extends beyond
the edge of the flat surface.
8 Remove the screw cover from the memory access
panel by lifting it up and away from the computer.
9 Remove the screw at the top of the memory access
panel using a flathead or Torx screwdriver.
10 Slide the memory access panel toward the center of
the computer until it stops (approximately 5 cm or
1/5 inch).
11 Lift up the outside edge of the panel approximately
2.5 cm (1 inch) (1) and slide the panel toward the
outside edge of the computer (2) to remove it.
IMPORTANT: If you are removing both cards on one
side, you must remove the upper one before removing the
lower one. Remove 1 before 3. Remove 4 before 2.