StoreEver LTO SAS half height tape drives user guide

Figure 12 SAS with power cable supplied with LTO–6 Ultrium 6250 and LTO-5 Ultrium 3000
internal tape drives
Unused second branch on supplied cable2.Mini-SAS connector to server (remove cover)1.
SAS connector to tape drive4.Mini-SAS connector on second branch (unused,
do not remove cover)
3.
Power cable and connector to server's power
supply
5.
The SAS connector on the cable supplied with all other HP LTO Ultrium tape drives does not provide
power. There is a separate power connector on the rear of the tape drive.
Figure 13 SAS without power cable supplied with all other LTO internal tape drives
Unused second branch on supplied cable2.Mini-SAS connector to server (remove cover)1.
SAS connector to tape drive4.Mini-SAS connector on second branch (unused,
do not remove cover)
3.
NOTE: The cable supplied with the tape drive is suitable for connecting to a mini-SAS
(SFF-8086/8087) connector on a dedicated HBA or on the server's SAS controller. If your server
has a SAS 4i connector (SFF-8484), a suitable cable is available, but must be purchased separately,
see http://www.hp.com/storage/spock.
Option 1: Connect to a new HBA (all servers)
The following instructions are valid ONLY IF you have purchased and installed an additional HBA.
See (page 15) and always refer to http://h20272.www2.hp.com/ BEFORE installing your tape
drive.
Connect SAS and power cords 19