StoreEver LTO SAS half height tape drives user guide

Figure 30 Front view of earlier LTO Ultrium external tape drives
5. Drive LED1. Cartridge door
6. Ready LED2. On/Off switch (external drives only)
7. Eject button3. Clean LED
4. Tape LED
Loading a cartridge
1. Lift the cartridge door (4) and insert the cartridge into the slot in the front of the drive with the
arrow uppermost and facing the drive door(2).
Figure 31 Inserting a cartridge
2. Arrow indicates leading direction1. Label area
4. Cartridge door3. Ready light
2. Apply gentle pressure until the drive takes the cartridge and loads it. (See figure above.)
3. The Ready light (3) flashes green while the drive performs its load sequence. When the cartridge
is loaded, the Ready light shows steady green.
Loading a cartridge 33