StoreEver LTO SAS half height tape drives user guide

Table 4 Clean, Tape, Drive and Ready LED sequences (continued)
Action requiredCauseLED Sequence
See Running HP OBDR (page 42) for further
details.
The drive is in OBDR mode.
Ready FLASHES- steady ON-
FLASHES.
None.The drive is downloading
firmware.
Do not reset or power cycle the drive.
Ready FLASHES fast.
None.Firmware is being
reprogrammed.
Do not reset or power cycle the drive.
Ready is OFF, others are ON.
Load the Ultrium cleaning cartridge. See Cleaning
cartridges (page 35) for supported cartridges and
instructions.
The drive requires cleaning.
If the Clean LED is still flashing when you load a
new or known good data cartridge after cleaning,
call for service.
Clean FLASHES.
None. The cleaning cartridge will eject on
completion.
Cleaning is in progress.
The cleaning cycle can take up to 5 minutes to
complete.
Ready FLASHES and Clean is
ON.
Unload the tape cartridge. Make sure that you are
using the correct format cartridge; an Ultrium data
The drive believes the current
tape or the tape just ejected is
faulty. cartridge or Ultrium Universal Cleaning Cartridge.
(See Use the correct media (page 35).)
Tape FLASHES.
Reload the cartridge. If the Tape LED still flashes
or starts flashing during the next backup, load a
new or known good cartridge.
If the Tape LED is now off, discard the 'suspect'
tape cartridge. If it is still on, call for service.
Write protect the cartridge by sliding the switch
on the tape cartridge, see Write protecting
The tape cartridge memory (CM)
may be faulty.
cartridges (page 38). The tape can be loaded and
the data read. Once the data is recovered, the
cartridge must be discarded.
The tape is ejected immediately
and Tape FLASHES, or Drive
FLASHES on unloading tape.
Load a new cartridge. If the error persists, power
cycle or reset the drive.
The drive mechanism has
detected an error.
If the Drive LED remains on, call for service.
Drive FLASHES.
Understanding LED sequences 51