HP R3000v ERM User Manual

INSTALLATION

HP R3000v ERM User Guide S 164201732 Rev 1

Place the cabinet in a protected area that has adequate airflow and is free of humidity,

flammable gas, and corrosion.

NOTE: Discard the ERM user guide if you are installing the ERM with a new UPS at the same

time. Use the UPS user guide to install both the UPS and ERM.

Rackmount Installation

The HP R3000v rackmount cabinet comes with all hardware required for installation in a

standard EIA or JIS seismic rackmount configuration with square and round mounting holes.

The rail assemblies adjust to mount in 48-cm (19-inch) racks with front to rear rail distances

from 61 to 76 cm (24 to 30 inches) deep.

Checking the Rail Kit Accessories

Verify that the following rail kit items are included for each cabinet:

S Left rail assembly:

-Leftrail

-Rearrail

-(3)M4

×8 pan-head screws

S Right rail assembly:

- Right rail

-Rearrail

-(3)M4

×8 pan-head screws

S Rail hardware kit:

- (10) M6

×16 pan-head screws

- (10) M6 hex cage nuts

- (10) M6 square cage nuts

- (2) rear stop brackets

-(6)M3

×8 pan-head screws

S Mounting bracket kit:

- (2) mounting brackets

-(8)M4

×6flat-headscrews

Tools Required

To assemble the components, the following tools may be needed:

S Medium flat-bladed screwdriver

S Phillips

#2 screwdriver

S 7 and 8 mm wrench or socket