HP R3000v ERM User Manual

INSTALLATION

HP R3000v ERM User Guide S 164201732 Rev 1

2. SelecttheproperholesintherackforpositioningtheERMintherack(seeFigure2).

The rails occupy four positions on the front and rear of the rack.

3. Secure one rail assembly to the front of the rack with one M6

×16 pan-head screw

and one M6 cage nut.

4. Using two M6 cage nuts and two M6

×16 pan-head screws, attach the rail assembly

to the rear of the rack.

M6×16 Pan-Head

Screws (6 places)

Front of Rack

M6 Cage Nuts

(6 places)

Tighten

adjustment

screws after rail

attachment

(3 places each rail).

Position 4

Position 1

Figure 2 Securing the Rails

5. Repeat Steps 3 and 4 for the other rail assembly.

6. Tighten the three adjustment screws in the middle of each rail assembly.

7. If installing more than one ERM, repeat Step 1 through Step 6 for each rail kit.

8. Place the ERM on a flat, stable surface with the front of the cabinet facing toward you.

9. Align the mounting brackets with the screw holes on each side of the ERM and secure

with the supplied M4

×6 flat-head screws (see Figure 3).

NOTE: There are two sets of four mounting holes on each side of the ERM: a forward position

and a m iddle position. Choose the position that meets your configuration needs.

Mounting

Bracket

M4×6Flat-Head

Screws (4 places)

Figure 3 Installing the Mounting Brackets (Forward Position S hown)

10. If installing more than one ERM, repeat Steps 8 and 9 for each cabinet.