HP R3000v ERM User Manual

INSTALLATION

HP R3000v ERM User Guide S 164201732 Rev 1

Rackmount Wiring Installation

To install the ERM:

1. Remove the UPS right front bezel (behind the control panel). See Figure 6.

To remove the bezel, loosen the two captive screws on the right side of the bezel.

Grasp the top and bottom of the bezel and slide the bezel to the right.

NOTE: A ribbon cable connects the control panel to the UPS. Do not pull on the cable or

disconnect it.

NOTE: Leave

ribbon cable

connected.

Figure 6 Removing the UPS Right Front Bezel

2. On the bottom of the UPS right front bezel, remove the ERM cable knockout. See

Figure 7.

NOTE: Use care to protect the control panel and the connected ribbon cable from damage.

ERM Cable Knockout

Figure 7 Removing the ERM Cable Knockout