HP R3000v ERM User Manual

HP R3000v ERM User Guide S 164201732 Rev 1
3
Chapter 2 Installation
NOTE: If you are installing the UPS and the Extended Runtime Module (ERM) together, follow
the installation instructions in the UPS user guide.
NOTE: ERMs can be installed e asily without turning the UPS off or disconnecting the load. If
you prefer to remove input power to install an ERM, refer to “UPS Shutdown” in the UPS user
guide.
This section explains:
S Equipment inspection
S Unpacking the cabinet
S Checking the accessory kit
S ERM installation
Inspecting the Equipment
If any equipment has been damaged during shipment, keep the shipping cartons and
packing materials for the carrier or place of purchase and file a claim for shipping damage.
If you discover damage after acceptance, file a claim for concealed damage.
To file a claim for shipping damage or concealed damage: 1) File with the carrier within
15 days of receipt of the equipment; 2) Send a copy of the damage claim within 15 days
to your service representative.
NOTE: Check the battery recharge date on the shipping carton label. If the date has expired
and the batteries were never recharged, do notusetheUPS.Contactyourservice
representative.
Unpacking the Cabinet
CAUTION
S Unpacking the c abinet in a low-temperature environment may cause condensation to occur
in and on the cabinet. Do n ot install the cabinet until the inside and outside of the cabinet
are absolutely dry (hazard of electric shock).
S The cabinet is heavy (see page 17). Use c aution to unpack and move the cabinet.
Use care when moving and opening the carton. Leave the components packaged until
ready to install.
To unpack the cabinet and accessories:
1. Open the outer carton and remove the accessories packaged with the cabinet.
2. Carefully lift the cabinet out of the outer carton.
3. Discard or recycle the packaging in a responsible manner, or store it for future use.