HP R3000v UPS User Manual

INSTALLATION

HP R3000v UPS User Guide S 164201731 Rev 1

Rackmount Wiring Installation

This section explains:

S Installing the UPS, including connecting the UPS internal batteries

S Connecting any optional ERMs

Installing the UPS

NOTE: Do not make unauthorized changes to the UPS; otherwise, damage may occur to your

equipment and void your warranty.

NOTE: Do not plug the UPS power cord into a power outlet until after the installation is

completed.

To install the UPS:

1. RemovetheUPSrightfrontbezel.SeeFigure8.

To remove the bezel, loosen the two captive screws on the right side of the bezel.

Grasp the top and bottom of the bezel and slide the bezel to the right.

NOTE: A r ibbon cable connects the control panel to the UPS. Do not pull on the cable or

disconnect it.

NOTE: Leave

ribbon cable

connected.

Figure 8 Removing the UPS Right Front Bezel