HP R3000v UPS User Manual

INSTALLATION
HP R3000v UPS User Guide S 164201731 Rev 1
12
Connecting the ERM(s)
To install the optional ERM(s) for a UPS:
1. On the bottom of the UPS right front bezel, remove the knockout for the ERM cable.
SeeFigure10.
NOTE: Use care to protect the control panel and the connected ribbon cable from damage.
ERM Cable Knockout
Figure 10 Removing the Knockout
2. Remove the front bezel of each ERM. See Figure 11.
To remove the bezel, loosen the two captive screws on the right side of the bezel.
Grasp the sides of the bezel. Slide the bezel to the left and then away from the
cabinet.
Bottom ERM Cable Knockout
(underneath bezel)
Top ERM Cable Knockout
ERM Bezel Hook
Figure 11 Removing the ERM Front Bezel