HP R3000v UPS User Manual

UPS MAINTENANCE

HP R3000v UPS User Guide S 164201731 Rev 1

Transporting the UPS

NOTE: The UPS internal batteries MUST be disconnected during transport.

If the UPS requires any type of transportation:

1. Verify that the UPS is unplugged and turned off.

2. RemovetheUPSrightfrontbezel.SeeFigure18.

To remove the bezel, loosen the two captive screws on the right side of the bezel.

Grasp the top and bottom of the bezel and slide the bezel to the right.

NOTE: A r ibbon cable connects the control panel to the UPS. Do not pull on the cable or

disconnect it.

NOTE: Leave

ribbon cable

connected.

Figure 18 Removing the UPS Right Front Bezel

3. Disconnect the internal battery connector (see Figure 19).

Figure 19 Disconnecting the UPS Internal Batteries

4. Replace the UPS front bezel.