HP Value UPS Manager User Manual

34
2. Receiver: The mobile phone numbers that can receive the SMS. It can be one or more. If the Event
that you have selected occurs, the HP Value UPS Manager will send the short message to all the
phone numbers in the "Receiver" list.
3. Send messages: A user can select the events that need to be informed by SMS.
Note: If the OK button is an invalid condition, which means your access rights to the current Agent are
"Read Only" and you cannot carry out these operations, you may log in as a super user through
the "Act as Administrator" menu.
17) "Monitor Remote Device" Screen
The "Monitor Remote Device" screen will show when a user selects the "Monitor Remote Device”
menu item from the "Monitor" menu. Refer to the following diagram 3-2-17-1:
Diagram 3-2-17-1
Enter the IP address of an Agent to be monitored and then press the OK button.
The software
supports both IPv4 and IPv6, and the user can input the address of IPv4 (for example: 192.168.5.106) or
the address of IPv6 (for example: fe80:21b:b9ff:fe5b:5ad4). If this agent exists, the information will be
displayed below the "WAN" node in the tree view of the Manager Window.
Note: 1) the maximum of remote agents that can be monitored is 32.
2) If HP Value UPS Manager can't communicate with a remote agent in 1 minute, it will be
prompted user: Network communication lost.
3) You can manually delete a remote agent by selecting the agent node below "WAN". Right click
to show a delete pop up menu, and select the "Delete" menu item to remove it.
18) Bottom image
If you select the submenu “Bottom Image” of the menu item “Preference”, you can change the bottom
image of the interface. See diagram 3-2-18-1: