HP Value UPS Manager User Manual

phone numbers in the "Receiver" list.

3. Send message: The user can select the events that need to receive SMS.

Finally select the “OK” button to save and exit.

Another method to select an Event Code:

Select one of the events (For example, AC Fail) from the “Event List”, which is on the left side of

the “Event Action”, and then select “Send SMS” on the right side of the screen. Finally, select the “OK”

button to save and exit.

11. How to remotely control any device in the LAN within the same network

9 Precondition

To remotely control any device in LAN within the same network, the computers being required to

setup for HP Value UPS Manager must have TCP/IP protocol in their communication protocol. The

ports that the software needs to be open by the firewall, refer to table 4-11-1

Port TCP/UDP

2198 UDP

2199 UDP

2200 UDP

2099 TCP

Table 4-11-1

9 Steps for use

¾ Keep network communication normally: test with a network command PING under the command

prompt window. For example, a computer named XC in LAN, whose corresponding IP address is

192.168.1.221, and then you can finish the test with the command ping 192.168.1.214. See the

following Diagram 4-11-1: which indicates that the physical link of LAN is normally.

Diagram 4-11-1

¾ Remote Control Permission Switch: This is a selectable menu item. The user can open the

submenu “Accept Remote Device” of the menu “Monitor” in the HP Value UPS Manager in the

computer with the appointed IP.

Refer to the following diagram 4-11-2: