HP Value UPS Manager User Manual

Diagram 4-11-4

12. How to remotely control any device in a different network in LAN

¾ The computers being setup for HP Value UPS Manager must setup the TCP/IP protocol in the

communication protocol.

The ports that the software needs open by the firewall, refer to table 4-12-1

Port TCP/UDP

2198 UDP

2199 UDP

2200 UDP

2099 TCP

Table 4-12-1

9 Steps for use

¾ Keep the communication normally: test with network command PING.

¾ Remote Control Permission Switch: This is a selectable menu item. The user can open the

submenu “Accept Remote Device” of the menu “Monitor” on the HP Value UPS Manager in the

computer with the appointed IP

Refer to the following diagram 4-12-1: