HP Wireless Lan Access Point (P1981A) , Installation Guide

English 7
Powering the HP Wireless LAN Access Point
There is no On/Off switch on the HP Wireless LAN Access Point. This is because the
device uses very little power.
To power-up the device:
1 Plug the power adapter into a power outlet to start the power-up process.
CAUTION After applying power to the Wireless LAN Access Point, do not cover the device or
block the airflow to the device with any other objects.
2 Monitor the LED activity on the device. The LEDs will change color between
Yellow, Red and Green. When finished, the Wireless LAN Access Point shows
LED activity as listed in the table below.
NOTE If the HP Wireless LAN Access Point does not switch to normal operation within one
minute, try to solve the problem with the troubleshooting information in the online
manual on the CD-ROM.
Power LED
Wireless LED
Ethernet LED
Telephone/Modem LED
Name Color/Activity Description
Power Steady Green Power enabled
Wireless Off, or Flashing
Green or Red
Wireless activity
Ethernet Off, or Flashing
Green or Red
Ethernet activity
Telephone/
Modem
Off, or Flashing
Green or Red
Modem activity
ap-us.book Page 7 Thursday, November 16, 2000 10:36 AM