Installing HP-UX 11.0 and Updating HP-UX 10.x to 11.0 HP 9000 Computers Edition 1

Chapter 5 103
Installing from the Ignite-UX Server
Network Source Installation
If the client system is already running an OS, you may use this
procedure or use the bootsys command as described in “Non-Interactive
Installation Using bootsys”.
Procedure 1. Determine your network server address for the install. If necessary,
see your system administrator for this information.
2. Turn on your target system.
3. When you see a message about stopping the boot search, quickly
press and hold ESC to stop the boot selection process.
Older Series 700
On older Series 700 machines, you will eventually see the following. (For
HP 9000 Workstations, see the section “HP 9000 Workstations and
Servers (K/D Class)”, in this chapter.)
Figure 5-2
b) Boot from specified device
s) Search for bootable devices
a) Enter Boot Administration mode
x) Exit and continue boot sequence
?) HelpSelect from menu:
Do one of the following:
• If your network has only one install server and your system is not
configured as a diskless client, then type:
boot lan
The boot may fail the first time because of an intentional delayed
response by the install server. If it fails, try it again. If it fails more
than three times, check for problems on the install server (see
Chapter 7, “Troubleshooting,”) OR
• If your network has multiple install servers, make sure you boot from
the network server address specified by your system administrator.
To Search for Servers: 1. Type the following:
search lan Enter
2. If your Ignite-UX server does not appear during the search, type "x"
in order to exit.
• If necessary, type the search command again: